Go to the Home Page - IECI Logo

Interworld Electronics

 
and Computer Industries Inc.         
Interworld Electronics Home Page
 Home   Data Acquistion   Advantech   ADAM  4050
Remote Data Acquisition & Control (ADAM
Digital I/O Cards
PC-Based Industrial Workstations
Industrial PC Chassis
Industrial Communication Cards (ICOM)
Download Utility Software
Software
ADAM-4050
Digital I/O Module


 

Introduction
Applications
Specifications
Ordering Information
Put Links and images as needed here
  Introduction Return to top of page

Simple configuration, easy programming and supported by major DA & C packages - these are just a few reasons to use Advantech's ADAM 4000 modules.

The analog input module's two digital output channels are open-collector transistor switches that you can control from the host computer. By switching solid state relay the output channels can control heaters, pumps and other power equipment. The module can use its one digital input channel to sense the state of a remote digital signal

Analog input modules include high and low alarm signaling with remotely configurable limit values. After every A/D conversion, the digital value is compared with the high and low limit. The module can change the state of a digital output depending on the result of this comparison. This lets it perform On/Off control of a device independent of the host PC.

The on-board event counter can count up to 65,535 transitions occurring on the digital input. The counter can be read and cleared by the host computer. the counter can be used in production line applications to keep a record of repetitive operations.

The ADAM-4050 features seven digital input channels and eight digital output channels. The outputs are open-collector transistor switches that you can control from the host computer. You can also use the switches to control solid-state relays, which in turn can control heaters, pumps or other power equipment. The host computer can use the module's digital inputs to determine the state of limit or safety switches or remote digital signals.

Easy-to-use menu-driven utility software make configuration and calibration a snap. Its terminal emulation program lets you easily read from and write to ADAM modules. Writing application programs with this software (GENIE 2.0) is simple, you can learn the basics in just a few minutes.

Applications Return to top of page

  •  Control heaters, pumps or other power equipment

SpecificationsReturn to top of page

Communication

  • RS-485 (2-wire) to host
  • Speeds: 1200, 2400, 4800, 9600, 19200 bps
  • Max. communication distance: 4000feet (1.2Km)
  • Power and communication LED indicator
  • ASCII command/response protocol
  • Communication error checking with checksum
  • Asynchronous data format: 1 start bit, 8 data bits, 1 stop bit, no parity
  • Up to 256 multidrop modules per serial port
  • On-line module insertion and removal
  • Transient suppression on RS-485 communication lines

Power Requirements

  • Unregulated +10 +30 VDC
  • Protected against power reversal

Mechanical

  • Case: ABC with captive mounting hardware
  • Plug-in screw terminal block:
    Accepts 0.5 mm² to 2.5 mm²
    1-#12 or 2-#14 to #22 AWG

Environment

  • Operating temperature: 14 to 158ºF (-1000 to 70ºC)
  • EMI: Meets FCC Class A
  • Storage temperature: -13 to 185ºf (-25 to 85ºC)
  • Humidity: 5 to 95%, non-condensing

Digital Input Return to top of page

  • Channels: 7
  • Logic level 0: +1 V max.
  • Logic level 1: +3.5 V ~ +30 V
  • Pull up current: 0.5 mA, 10 K OHM resistor to +5V

Digital Output

  • Channels: 8
  • Open collector to 30 V, 30 mA max. load
  • Power dissipation: 300 mW

Power

  • Power requirements: +10 to +30 V (non-regulated)
  • Power consumption: 0.4 W

 

Ordering Information Return to top of page

ADAM-4050

Digital I/O Module (7DI, 8DO)

Return to top of page


 USA Office: Tel: 1-877-902-2979    Fax: 1-877-FAX-IECI     Pacific  Time Zone    
                   Tel:1-425-223-4311    Fax: 1-425-223-4303     Pacific Time Zone
P.O. Box 1280. Street Address: 145 Tyee Drive, Point Roberts, WA 98281

Sales inquiries to:  sales at interworldusa.com  Support & Service: support at interworldusa.com

Western Canada: - Vancouver, B.C. Tel: 1-(604) 925-6150    Fax: 1-(604) 925-6170 Toll Free:1-(800) 663-6001

    2454 Haywood Ave, West Vancouver, B.C. V7V 1Y1
  Eastern Canada: - Markham, Ontario Tel: 1-(905) 513-7027    Fax: 1-(905) 513-7029 Toll Free:1-(800) 465-0164
3555 14th Ave, Unit 12, Markham, Ontario L3R 0H5

Sales inquiries to:  sales at interworld.ca    Support & Service: support at interworld.ca

To visit our Australian web site, please click here.